The 900 MHz Touchless Retrofit Transmitter allows an existing, hard-wired, touch, push plate to be
retrofitted with a new touchless plate that requires four (4) wires (2 wires for power and 2 wires for
activation) without running additional wires.

In most applications for existing hard-wired touch push plates, only two (2) wires are installed which
run within the wall from the push plate to the door control for activation.

This is achieved by use of a powered wireless transmitter and wireless receiver.
1. Remove existing touch push plate and disconnect the two (2) existing in-wall wires from the push plate and door control activation.
2. Connect the green and white wires to the new touchless plate activation output (see image below).
3. Parallel the red and black wires with the two (2) existing in-wall wires and connect them to the new touchless plate power input (see image below).
4. Mount new touchless plate.
5. Connect the two (2) existing in-wall wires to the power source in the door control header.
6. Install the 900 MHz wireless receiver in the header (sold separately).