Basic installation of Electric latch retraction kit.  Device may vary.

Retrofit Installation Note: 42" or48"exit devices that have been
modified to fit a 36" or smaller opening, may not have the required
space to fit the standard E. L. R. assembly.
Always verify the distance from the end of the touchpad to the end rail,
and if necessary, consult with the factory for appropriate selection.

Only 700 mA Inrush - 24VDC @ 700/200mA
SDC LR100 Series Electric Latch Retraction Kit enables electric access
control and dogging of mechanical exit devices.
When energized the motor retracts the exit device latch and pulls the
pushpad on most devices into the dogged (depressed) position enabling
momentary or sustained push and pull operation of the door.

Installation required.

700 mA Inrush**, 200 mA Continuous @ 24VDC
For access control and sustained dogging applications
Simultaneous latch retraction and dogging (pushpad depressed) for most exit devices*
Pushpad is depressed* electrically for quieter push / pull operation
Automatic re-trigger if device does not pull on first try
Eliminates need for costly replacement of existing exit device
Significantly less labor and costs compared to competitive retrofit kits
Low current enables longer wire runs with smaller gauge wire
No door sequencers required for pairs of manual doors
Installs in Von Duprin non-fire rated panic device without removing from the door

QUIET DUO™ LR100 Series available for these brands:
• Von Duprin
• Yale
• Corbin Russwin
• Design Hardware
• Hager
• Adams Rite
• Stanley K2
• IDC
• TownSteel
• Arrow
• PHI
• Falcon
• Cal-Royal
• PDQ
• Falcon Dor-O-Matic
•Marshall Best
• Sargent
• SDC
• First Choice
•Tell
•Detex
• Marks
• Dorma
• Jackson
• Pamex

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating     Bad           Good

Captcha

Please complete the captcha validation below

Continue