• MS1861-02 Adams Ritebottom rail deadlock (two point) - less cylinder

*Actual product and finish may vary

MS1861-02 Adams Rite Bottom Rail Deadlock (two Point) is for use on full glass (Frameless) doors. Less cylinder.

ANSI/BHMA Type E8211 (Grade 1)

Bolt Operation – Vertical & Horizontal Bots

603 Zinc



MS1861-02 Bottom Rail Deadlock

Cylinder Backset

Minimum backset is approx. 2-1/4“ for the MS1861-01, with vertical bolt only. The MS1861-02, with vertical and horizontal bolt, requires placement of cylinder centerline 5-3/4” from nose of door. Both have cylinder center 1-7/8” above bottom edge of door.

Case

Steel with corrosion-resistant plating. 1“ x 6” x 1-13/16”.

4014 Conversion Kit

To convert MS1861-01 to MS1861-02, Kit 4014 provides horizontal bolt assembly with guide and attachment fittings.

Function

Using the same overcenter/pivot locking mechanism as the basic MS® deadbolt, the MS1861 lies horizontally in the bottom rail of ultra-narrow stile doors, which have insufficient vertical space for a lock and tempered glass doors, which have no stile at all. The hardened steel cylindrical bolts allow simple drilled strike holes of a relatively small size to minimize the nuisance and danger presented by some threshold strikes in collecting debris and catching women’s heels.  MS1861-02 locks either single-leaf or paired doors.

Bolts

3/8“ diameter. Stainless steel vertical threshold bolt has 13/16” throw. Hardened steel horizontal bolt has 1-1/8” throw.

Strikes

In metal installations, 7/16“ drilled holes in threshold are required. For MS1861-02, drilled holes are also required in jamb or opposite door. For wood, metal plate with 7/16” hole must be provided for each bolt.

Operation

360° turn of key or thumbturn throws or retracts bolt(s). Key can be removed only when bolts are in a positively locked or unlocked position. Lock accepts any standard 1-5/32“diameter mortise cylinder from either or both sides. Cylinder must have MS® cam. 

Cylinder Cam

MS1861 Series locks are operable by any standard 1-5/32“ diameter mortise cylinder with special MS® dimensioned cam. Cylinders with MS® cams can be readily obtained from most cylinder manufacturers. See catalog for cylinder make and trim ring information.

Standard Package

Individually boxed with mounting screws. Cylinders and/or thumbturn available at extra cost. Shipping weight: MS1861-01: 1-3/4 lbs., MS1861-02: 2 lbs.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

MS1861-02 Adams Ritebottom rail deadlock (two point) - less cylinder

  • $128.87


Available Options



20-013 Schlage Mortise Cylinder, 1-1/8" AR Cam

20-013 Schlage Mortise Cylinder, 1-1/8" AR Cam

20-013 Schlage Mortise Cylinder conventional (standard) 1-1/8” with AR cam for use with Adams Rite M..

$66.85